IMPORTANT : Il est recommandé d'indiquer votre localisation dans votre profil afin que l'ensemble des membres puisse vous aider dans vos recherches.
AVIS: Les messages de plus de 30 jours sont supprimés.
AVIS: Les messages de plus de 30 jours sont supprimés.
Atlas 42B perceuse
- Creation Caco
-
Auteur du sujet
- Hors Ligne
- Membre premium
-
- Messages : 8094
- Remerciements: 1147
Atlas 42B perceuse
il y a 11 ans 7 mois
Je cherche toujours une poulie pour mon Atlas 42B, un de mes chums sur un autre forum, m'a demandé de prendre les mesure comme suit:
Measure the O.D. and then use equal sized pins such as 2 - 1/4 drill Bits and put the drills in the root of the spline and measure across the pins, subtract the 2x pin Dia. and that gives you the root Dia.
Then if you can measure the width of the tooth at the root and crest that will give you a starting point for accessing a Spline Hub.
I doubt its a standard spline but you never know!
hihihi, du Chinois pour moi, y a tu quelqu'un qui pourrais me dire les dimensions exacte du main shaft et de la poulie, j'essaye avec Google, mais vu que j'ai seulement slow internet, cela me prend des heures juste pour faire une recherche simple.
Merci
Jacques
Measure the O.D. and then use equal sized pins such as 2 - 1/4 drill Bits and put the drills in the root of the spline and measure across the pins, subtract the 2x pin Dia. and that gives you the root Dia.
Then if you can measure the width of the tooth at the root and crest that will give you a starting point for accessing a Spline Hub.
I doubt its a standard spline but you never know!
hihihi, du Chinois pour moi, y a tu quelqu'un qui pourrais me dire les dimensions exacte du main shaft et de la poulie, j'essaye avec Google, mais vu que j'ai seulement slow internet, cela me prend des heures juste pour faire une recherche simple.
Merci
Jacques
Membre du RARMA
Connexion ou Créer un compte pour participer à la conversation.
